8. Details on the front sides
Cut out the headlights from plastic insulation from cables, approx 3 mm for the lower and 4 mm for the top headlight.
The lower lights must be cutted sloping at the surface, who corresponds to the front side rounding.
15. Top headlight
16. Horn (missing on the picture above). A cone of thin paper, according to the drawing.
17. Lower headlights
18. Buffers, of tacks
19. Couplers, of bended metal wire, diam. 0,40 mm
20. Ploughs. Ovals of thin paper(or plastic foil) bended in the length direction.
21. Air tubes, of bent metal wire, diam. ca 0,40 mm.
22. Footplate, cutted out in ca 0,5 mm pasteboard.
Glue the ploughs (sloping) against the outer ends of the underframe. Eventually, a piece of pasteboard can serve as
reinforcement behind.
If you are building a model with function: the buffers (tacks) shall not reach out from the inside of the bufferbeam, because
the space within must be free due to the motorchassis.